Thermostat Installation

Warmboard Comfort System offers two different types of thermostats:

  • Heating
    Controls the heat in one zone.
  • Heating/Floor Warming
    Controls the heat in one bathroom and offers a warming feature which keeps the floor warm even when there is no call for heat.

 

Warmboard thermostat install in wall

Installation Steps

Each thermostat must be installed in the location specified in the WCS Plan Set. Failure to do so will cause the system to perform erratically. If there are any discrepancies regarding the thermostat or zoning, contact us immediately.

  1. Remove the appropriate thermostat from the box.
  2. Grip the thermostat on the sides with one hand, and the back of the thermostat with the other hand, then slowly separate the pieces.
  3. Set the face aside.
  4. Connect the Line and Neutral (black and white) wires from the back plate (power supply) to the connections in the junction box, then fasten into place with the provided screws – be sure the arrows point up.
  5. Snap the face of the thermostat back into place. Repeat for each thermostat, always reference the Equipment and Piping Layout in the WCS Plan Set to check for thermostat locations.
  • After texture and paint, each thermostat must be installed in the correct location in order for the system to perform properly.

Enter your Project ID and Project Location Zip Code